Floatplane (XC-47) Settings and Operation

When starting an aircraft at the end of a runway (even water!), the default configuration is gear down.  In the water, however, unless certain game settings are made, this will ordinarily cause the aircraft to go into crash mode.  To avoid this, on the first screen that comes up after starting the simulator; go to the Settings screen, and under Realism, in the Flight Model box, set the Crash Tolerance slider full left to Easy.  Then, in the Crashes and Damage box, click on the radio button that says Ignore crashes and damage. 

Water taxiing  In testing routes, and land/water  water/land transition at different hanger locations, anomalies in the MS scenery were noticed that, while affecting realism, and to a small extent movement, do not interfere with seaplane operation.  In some instances, and at some locations, taxiing floatplanes will occasionally encounter speed bumps in the water where the aircraft will appear to hop up a little on one or both floats as though hitting a sandbar. However, with sufficient power the plane will continue to taxi just fine.

Land Water Transition  Taxi slowly to ramp with gear up.  When stopped by land, raise water rudders and lower landing gear.  Slowly taxi forward until firmly established on land then taxi normally to destination.  Initially, if you approach the ramp too fast, the plane will jump out of the water onto the ramp accompanied by much noise, occasional sparks, and a temptation to four-letter words as the floats hit the concrete.  After a little practice, you will be able to avoid this.

